Pushing limits of photovoltaics and photodetection using radial junction nanowire devices

Abstract

Nanowire devices have long been proposed as an efficient alternative to their planar counterparts for different optoelectronic applications. Unfortunately, challenges related to the growth and characterization of doping and p-n junction formation in nanowire devices (along axial or radial axis) have significantly impeded their development. The problems are further amplified if a p-n junction has to be implemented radially. Therefore, even though radial junction devices are expected to be on par with their axial junction counterparts, there are minimal reports on high-performance radial junction nanowire optoelectronic devices. This paper summarizes our recent results on the simulation and fabrication of radial junction nanowire solar cells and photodetectors, which have shown unprecedented performance and clearly demonstrate the importance of radial junction for optoelectronic applications. Our simulation results show that the proposed radial junction device is both optically and electrically optimal for solar cell and photodetector applications, especially if the absorber quality is extremely low. The radial junction nanowire solar cells could achieve a 17.2% efficiency, whereas the unbiased radial junction photodetector could show sensitivity down to a single photon level using an absorber with a lifetime of less than 50 ps. In comparison, the axial junction planar device made using same substrate as absorber showed less than 1% solar cell efficiency and almost no photodetection at 0 V. This study is conclusive experimental proof of the superiority of radial junction nanowire devices over their thin film or axial junction counterparts, especially when absorber lifetime is extremely low. The proposed device holds huge promise for III-V based photovoltaics and photodetectors.