Booster-based beam recycling for swap-out injection at the High Energy Photon Source

Abstract

Fourth-generation synchrotron light sources employ ultralow-emittance storage rings with stringent injection requirements. On-axis swap-out injection alleviates the dependence on storage-ring dynamic aperture, but high-charge operation requires an efficient injector architecture capable of producing high-charge replacement bunches. This paper presents the accelerator physics design and performance analysis of a booster-based beam-recycling swap-out injection scheme implemented at the High Energy Photon Source (HEPS). In this approach, the full-energy booster serves as both an injector and a high-energy accumulator. An extracted storage-ring bunch is returned to the booster, merged with a low-charge bunch previously injected from the linac and accelerated to full energy. Following high-energy damping, the merged bunch is reinjected into the original storage-ring bucket. The scheme avoids the need for a dedicated accumulator ring while enabling high-charge bunch replacement. The recycling scheme was commissioned through staged machine studies. Full recycling-chain simulations, commissioning studies, and measured performance analysis are presented. The measured results characterize the recycling operation and quantify the transmission efficiency and performance limitations of the complete recycling loop. These results demonstrate the feasibility of the booster-based beam-recycling architecture and establish its operational basis for high-charge swap-out injection in future fourth-generation synchrotron light sources.